Yfz450r service manual. Yamaha YFZ450R Repair and Service Manual 2009 YFZ 450R 2019-03-11

Yfz450r service manual Rating: 8,3/10 714 reviews

Yfz450r Service Manual

yfz450r service manual

Spring preload adjusting nut 3. Become a fan of Team Trigger Racing on Facebook!!! If it does not 1. If you are dismounting while climbing a hill. Install the spark plug cap. Remove the bolt, lift the rear of the fuel tank, and then tilt it back. If necessary, apply inches in depth. As the coolant heats up, it expands and flows into the reservoir tank.

Next

Yamaha YFZ450 Manual

yfz450r service manual

Air filter element frame 3. Install the fuel tank cap by turning it clockwise. Use a Removing the radiator cap when the trough or a similar object as shown. Could cause you to react more slowly. Remove the defective bulb and replace it 4. Turn the adjusting nut while holding the brake light switch in place.

Next

2009 Yamaha Yfz450r Manual

yfz450r service manual

Each cranking should be as short as possible to preserve battery ener- gy. You should periodically remove and inspect the 1. Measurement A: Installed length: A. Loosen the clamp screw at the throttle body side, and then disconnect the air intake duct from the throttle body. Inadequate lubrication may cause damage. If the brakes check the brake system. Thoroughly lubricate the drive chain with a special O-ring chain lubricant.

Next

2009 Yamaha YFM450RY YFZ450R Workshop Service Repair Manual DOWNLOAD 09

yfz450r service manual

Start the engine and rev it up approximate- the bolt holes. If the light does not come on, ask a Yamaha dealer to inspect it. To raise a headlight beam, turn the headlight beam adjusting bolt in direction a. When fully stopped, apply the rear brake as well, and then lock the parking brake. Spark plug wrench spark plug because heat and deposits will cause the spark plug to slowly break down and erode. Recommended lubricant: Lithium-soap-based grease 8-50.

Next

Yamaha YFZ450R service manual repair 2009 YFZ 450R

yfz450r service manual

Dismount on the uphill side or to a side if pointed straight uphill. Remove the coolant reservoir by removing the bolts. Lower grease nipple ×2 1. Operating with improperly serviced or If not, have a Yamaha dealer adjust it. If there is free play, have a Yamaha the brakes firmly for one minute.

Next

YFZ450 service manual download is here

yfz450r service manual

Place a container under the engine, and then remove the coolant drain bolt. On the inner parts of the master cylinder and caliper cylinder, replace the oil seals every two years. Brake lever position adjusting bolt 4. Allow a cooling off period of five to ten minutes after every hour of operation. Have a Yamaha tire pressure, may cause loss of control, dealer repair as necessary for proper operation. These labels contain important information for safe and proper operation.

Next

Yamaha YFZ450 & YFZ450R ATV Repair Manual 2004

yfz450r service manual

A separate starter circuit supplies this mixture. If a label becomes difficult to read or comes off, request a replace- ment label from your Yamaha dealer. It contains important safety information. After extensive tests, only the tires listed below have been approved for this model by Yamaha Motor Co. To check the drive chain slack, all tires must be touching the ground and there should be no weight on it. You should then release the parking brake.

Next

Yamaha YFZ450R Service Manual 2009

yfz450r service manual

If dust or water collects in this hose, empty the hose and clean the air filter element and air filter case. Pause a few seconds operating the engine for the first time. Contiene indicaciones importantes acerca de la seguridad. To apply the parking brake, move the parking brake lever in direction a. Tighten the locknut to the specified torque. Recommended lubricant: Lithium-soap-based grease Left side 1. Remove the wing bolt and washer from the air oughly in solvent.

Next

YZF450R

yfz450r service manual

Record the information on this label in the space provided. Remove the fuel tank cap by turning it coun- terclockwise. Loss of control can result in severe injury or death. To prevent this, the valve clearance must have the idle speed adjusted. For this reason, you should read the following material carefully.

Next