Differential gear oil drain bolt: 3. It also does not seem to take fuel in properly - it comes out the petcock ok so it is running freely enough, but it is not drawing into the carb. If the light comes on during operation, stop the en- gine as soon as it is safe to do so and allow the engine to cool down for about 10 minutes. If anyone has any ideas I would be very grateful. Replace diaphragm assembly if diaphragm is damaged. The coolant lev- Removing the radiator cap when the en- el will vary with engine temperature.
The fuel level can be observed with the engine either running or shut off, however, engine must run briefly to allow fuel level to stabilize. This manual is book marked by chapter for ease and fast navigation. This adjust- tion b to decrease the engine speed. Only change I found, was front brakes were upgraded to disk in 2001. Ignition Wipe clean with dry cloth. If necessary, apply 14 inches in depth.
Automotive type wax may be applied to ing. If necessary, remove the rear brake line from the master cylinder. Tap the tailpipe lightly, and then use a wire brush to remove any carbon depos- its from the spark arrester portion of the tailpipe. I started the engine and starter turned it over then it hit and stuck. Place bellcrank in neutral position. Be sure to re-attach the bowl drain hose after performing the test. Which side does the axle come out from,L or R? Remove the screws from the pump diaphragm cover.
If any damage is found, have them replaced by a Yamaha dealer. Lift up on the rear of the seat. Place a container under the engine, and gine and radiator are still hot. If correct free play cannot be obtained, ask a 1. Fuel expands when it heats up.
Install panels D and E. Look for discoloration, shiny spots, or an area that looks different than the rest of the needle. Drive select lever box check hose 1. Replace the spring if tabs aremisaligned or the spring coils are distorted. Tightening torques: Carrier bolt top : 26 Nm 2. Replace parts in proper order.
Motorcycle Triumph Trident T160 1975 Service Manual 5. Differential gear oil filler bolt: 2. I took the blow dryer out and de-iced it. Can someone point me in the right direction here? Check the sealing surfaces of the pump body and covers. Have a Yamaha dealer check the cause if Use only the designated quality brake fluid, the brake fluid level goes down. Learn to safely control skidding or sliding by prac- ticing at low speeds and on level, smooth terrain. Turn the adjusting bolt until the throttle le- ver free play is 3—5 mm 0.
Remove the bulb holder together with the bulb by turning it counterclockwise. Tightening torque: Engine oil drain bolt: 30 Nm 3. Remove output shaft and gear assembly along with sprocket and chain, by tapping on shaft with a soft faced hammer, from the back side of the gear case. Here is what I have collected over the years and maybe it will help someone else. Ive looked it up in the repair manual but it doesn't give any specific steps on how to do it.
Main switch The engine can be started only at this position and the headlights and taillight come on when the light switch is on. Install spring washer and drive shaft. Air filter case cover 3. Drive select lever box check hose 4. If it does not work smoothly, check for the cause. See page 4-20 for seat removal and installation proce- dures. Someone painted over the serial number.