Have unit serviced by your Tanaka dealer before operating. There could be a low speed adjust but not likely a high speed. Model 120 Carburetor has a fixed high speed jet screw which is preset at factory and does not need adjustment. ®,a product of Gold Eagle. He stocks genuine Tanaka parts and lubricants; manufactured with the same precision and skill as the original equipment.
After striking a submerged object, stop motor, wait for moving parts to stop, then remove wire from spark plug. Be sure flat of handle is set in notch of handle stopper. It takes us a bit to pull the appropriate manuals and get back to you with a combined cost. Repair any damage before restarting unit. Periodically check muffler and pipe for proper operation and carbon buildup.
If certified Tanaka service is not immediately available, proceed as follows. Premix Tanaka oil per instructions on container. Do you know where I can find one? Q - Can I get a carburetor rebuild kit for my motor? See Lubrication and Maintenance section for proper procedures. . The option to print the manual has also been provided, and you can use it by clicking the link above - Print the manual. While transporting these brochures, catalogues and sell sheets, we noted a oil smell that had permeated the paper, reminding me of the dark small rooms that were so full of the racks and boxes and bits and pieces that made up the old stock of this business. Your Tanaka Dealer will be happy to provide any service required to keep your Outboard Motor operating at peak efficiency.
Tanaka does not have parts for these motors, and we do not know where to get them. Original Vintage Tanaka Kogyo Co. If so can I order parts from Tanaka? Be sure the high speed jet is in place. Size: The manual measures approximately 8. My guess is the float is set wrong,bent,gas soaked. Spark Plug Gear Housing Cover Cotter Pin and Filter 5. Outboard Motor Owner's Manual 1.
The parts for this motor are no longer available. Q - Do you have any motors in stock? Float valve may be hanging up. If they dont have stock or cant get the parts for you email custsvc tanaka-ism. If you want to quickly view the content of pages found on the following pages of the manual, you can use them. Tanaka company recommends that you take your unit to your Tanaka dealer when these adjustment are necessary. It reminds me of the marinas I use to hang around as a kid. See your Tanaka enclosed or poorly ventilated areas.
Replace only with Tanaka original equipment replacement parts for safety. Q- Do you have parts for the Bumblebee outboard motor? If you are in a rush, pay for the individual shipping and we will refund the difference once packed for shipping. A - Feel free to check with your local Tanaka dealer. Motor Cooling Ignition System motor is air cooled, and air must circulate Test for faulty ignition system by removing spark freely around motor and over cooling fins plug from engine. We do combine shipping to save you money wherever we can. Model Carburetor has a fixed high speed jet screw which is preset at factory and does not need adjustment.
Secure to clutch case with 8 x 30 bolt, lock washer, and two plain washers. Flip the carb over and blow into the gas line. It starts ok, runs a little rough I'm assuming because the mix is too rich? Have unit serviced by your Tanaka dealer before operating. Advertisement Print version Many people prefer to read the documents not on the screen, but in the printed version. Choke Lever Dual Automatic Fill and Draln Plug Power Head Gear Housing Clutch Housing Fuel Sediment Bowl 4. Is there any adjustment on the carb jet? Tanaka 2-cycle oil has been formulated to insure maximum motor performance and increased motor life.
Replace Insure that motor stopped, wire from spark necessary. Starter Handle Cavitation Plate Reverse Driving Lock 2. I precisely mixed my fuel 50:1 and used 2-cycle oil made for chainsaws and outboards. Please enlarge the photos to determine the condition of the guide. This is especially true of propellers which may be of poor construction or improperly balanced.