The switch door lock is an inferior product. Filters is blocked in water inlet filter. Apply lemon juice and salt and place in the sun. Transit bolts are not removed. If stain remains, soak in cold water with an enzyme prewash. Drain hose is placed over 1m above the floor.
Prewashing helps loosen soil before washing. For Ordinary Tap 1 Pull down the. . Items should move easily through wash water for best cleaning and wrinkle-free results. Close the holes with the cap holders supplied. Cleaning your washer Winter storage or moving care Install and store your washer where it will not freeze.
Use ice in plastic bag to harden the gum. Clean and straighten the drain hose. Operation and temporary stop is repeated as it is pressed. Clean the pump filter Add the laundry to balance. Veuillez conserver ce manuel pour de futures références.
Operation and temporary stop is repeated as it is pressed. Place the drain hose under 1m above the floor. Scrape off any fresh paint and sponge with a non flammable dry cleaning fluid and wash normally. For your personal safety, this washer must be. Run washer through a complete cycle. For the more detailed information, please refer to the page 11~18. This section explains how to care for your washer properly and safely.
Wash lint producers and lint collectors separately. Keep the 4 bolts and spanner for future use. Change the water level sensor sensor pressure. Before operating the washer, remove the transit bolts 4ea along with the rubber. Water dose not enter the washing machine.
The laundry is concentrated to one side of the drum during spin. Occasionally wipe the outside of the washer to keep its looking like new one. Become familiar with all parts and features before using your washer. The amount of laundry is too small. The water level sensor sensor pressure is an inferior product or broke down. Wipe up detergent, bleach, and other spills with a soft, damp cloth or sponge as they occur.
Option : Be careful not to confuse hot water inlet and cold water inlet. Rub in a little detergent and wash in the maximum temperature allowed for the fabric type. Dampen a cloth with hydrogen peroxide, lay it over the affected area and press with a fairly hot iron. Operation and temporary stop is repeated as it is pressed. In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the cold water inlet valve.
If so shut down remove plug remove load , check if the agitator is jammed and reset. When you submit a report, we'll investigate it and take the appropriate action. Clean interior with 250ml of chlorine bleach mixed with 500ml of detergent. Option : Be careful not to confuse hot water inlet and cold water inlet. Keep the 3 bolts and spanner for future use. Straighten and clean the drain hose. V˝robek zlikvidujte jeho p¯edáním na sbÏrné místo pro recyklaci elektrick˝ch a elektronick˝ch za¯ízení.