2002 suzuki vitara owners manual. 2002 Suzuki Vitara Auto Repair Manual 2019-03-24

2002 suzuki vitara owners manual Rating: 7,2/10 1946 reviews

Suzuki Grand Vitara Workshop & Owners Manual

2002 suzuki vitara owners manual

Grommets 3 must be seated in place. Use care not to loose rotor stop key. To distinguish them, they are painted 1 figure. These repair guides will present you with the information that allows you to ensure that slight rattle does not become a big repair bill. If battery voltage is low, pressure becomes lower than specification even if fuel pump and line are in good condition. Number of pinion teeth Performance.

Next

Suzuki Grand Vitara Workshop & Owners Manual

2002 suzuki vitara owners manual

Engine basic inspection and engine symptom Go to Step 11. Grand Vitara was also sold in different badges like the Geo Tracker and the Pontiac Sunrunner. Each valve spring has top end large-pitch end 1 5 Install new valve stem seal 1 to valve guide. Circuit fuse in junction block assembly 8. The differential assembly is decisive in that the drive power is concentrated there. E23-15 — output On and after 2 sec. Check big-end of connecting rod for side clearance, Measure crank pin for out-of-round or taper with a with rod fitted and connected to its crank pin in the micrometer.

Next

Suzuki Grand Vitara 2002 2003 2004 2005 2006 repair manual

2002 suzuki vitara owners manual

Shown below is relative positions of drive bevel pinion, differential carrier and mounting dummy. Center differential lock switch 2. If found defective, 5 Install adjuster pawl lever 3 and adjuster spring. Be sure to connect and clamp each hose correctly as shown in figure. Fuel filter and fuel pump. Shown below is relative positions of drive bevel pinion, differential carrier and mounting dummy. Check oil pump chain for wear or damage.

Next

Suzuki Vitara Workshop & Owners Manual

2002 suzuki vitara owners manual

It should be modified according to conditions characteristic of each market. Ignition coil assembly for No. And once there, the driver appreciates a commanding see of the road, clouded by only a couple of small eccentricities. Heater core inlet hose 2. Front wheel hub assembly 4. For example, if number stamped on crank web No.

Next

2002 Suzuki Vitara Owners Manual

2002 suzuki vitara owners manual

Primary piston return spring 7. Check fuel tank inlet valve for the following. Intake Cam Timing Sprocket Assembly If measured runout exceeds limit, replace camshaft. It is produced in four generations; last version is in production since 2015. Ignition coil assembly for No. Disassembly Tightening torque 1 Remove 6 bolts, oil pump cover 1 , drive gear and Oil pump bolt a : 7. Oil Seal Tightening torque Check oil seal lip for fault or other damage.

Next

Suzuki Vitara Manuals at tooluser.org

2002 suzuki vitara owners manual

Oil is drawn up through the oil pump strainer and passed through the pump to the oil filter. Anyone who seeks to claim that their car is infallible will be lying to you. This step should be shared with the customer if possible. If damage is found, replace it with new one. Limit on side clearance 0. Direct clutch inner piston 3. If the measured values of length or tension is less than the specification, replace oil pump relief valve set.

Next

Suzuki Grand Vitara Workshop & Owners Manual

2002 suzuki vitara owners manual

Pressure control solenoid valve 17. Therefore, should caster be out of specification due to the damage caused by hazardous road conditions or collision, whether the damage is in body or in suspension should be determined and damaged body should be repaired or damaged suspension should be replaced. Journal clearance Standard Limit 0. Due to the fact that fuel feed line 1 is under high pressure, use special care when 2 Install pipes with pipe clamps to vehicle. If not, replace intake manifold tuning vacuum solenoid valve.

Next

Suzuki Grand Vitara 2002 2003 2004 2005 2006 repair manual

2002 suzuki vitara owners manual

However, the completely closed position of the throttle valve of the electric throttle body system signal voltage from throttle position sensor when throttle is completely closed differs one from the other depending on individual differences of the throttle valve and throttle position sensor. Installation To remove crankshaft pulley, use special tools 1 Clean sealing surfaces on timing chain cover, Steering wheel remover, Bearing puller attachment cylinder block and cylinder head. Malfunction of input shaft speed sensor Inspect. If engine oil contacts your skin, wash thoroughly with soap and water. Generator adjusting bolt For M16 Engine 9. It is so designed that the force created when the brake pedal is depressed is mechanically increased combined with the engine vacuum. Vitara models are run by a 127-horsepower 2.

Next